Command Manual - Network Protocol
Quidway S3500 Series Ethernet Switches Chapter 4 DHCP Client Configuration Commands
Huawei Technologies Proprietary
4-1
Chapter 4 DHCP Client Configuration Commands
 Note:
This chapter only applies to S3552G, S3552P, S3528G, S3528P, S3552F, S3526E,
S3526E FM, S3526E FS and S3526C in S3500 series switches.
4.1 DHCP Client Configuration Commands
4.1.1 debugging dhcp client
Syntax
debugging dhcp client { all | error | event | packet }
undo debugging dhcp client { all | error | event | packet }
View
User view
Parameter
all: All DHCP client debugging.
error: DHCP client error (including packet unrecognizable ) debugging.
event: DHCP client event (including address allocation and data update) debugging.
packet: DHCP client packet debugging.
Description
Using the debugging dhcp client command, you can enable DHCP client debugging.
Using the undo debugging dhcp client command, you can disable DHCP client
debugging.
By default, all DHCP client debugging is disabled.
Example
# Enable DHCP client event debugging.
<Quidway> debugging dhcp client event
To Next Page
Loading...
Need help?
General
