Command Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 3 AAA & RADIUS Protocol Configuration Commands
Huawei Technologies Proprietary
3-38
according to the regulation and packet format of IP Hotel (an extension of RADIUS
protocol).
portal: Configures the switch system to support the RADIUS server of portal type,
which requires the RADIUS client end (switch system) and RADIUS server to interact
according to the regulation and packet format of Portal (an extension of RADIUS
protocol).
standard: Configures the switch system to support the RADIUS server of Standard
type, which requires the RADIUS client end (switch system) and RADIUS server to
interact according to the regulation and packet format of standard RADIUS protocol
(RFC 2138/2139 or newer).
Description
Using server-type command, you can configure the RADIUS server type supported by
the switch. Using undo server-type command, you can restore the RADIUS server
type to the default setting
By default, the newly created RADIUS scheme supports the server of standard type,
while the "system" RADIUS scheme created by the system supports the server of
huawei type.
Quidway Series Ethernet Switches support standard RADIUS protocol and the
extended RADIUS service platform developed by Huawei Technologies.
For the related command, see radius scheme.
Example
# Set RADIUS server type of RADIUS scheme, “huawei” to huawei.
[Quidway-radius-huawei] server-type huawei
3.2.23 state
Syntax
state { primary | secondary } { accounting | authentication } { block | active }
View
RADIUS scheme view
Parameter
primary: Configures to set the state of the primary RADIUS server.
secondary: Configures to set the state of the second RADIUS server.
accounting: Configures to set the state of RADIUS accounting server.
authentication: Configures to set the state of RADIUS authentication/authorization.
block: Configures the RADIUS server to be in the state of block.
To Next Page
Loading...
Need help?
General
