Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 5 IP Routing Policy Configuration Commands
Huawei Technologies Proprietary
5-8
Parameter
route-policy-name: Specifies displayed Route-policy name.
Description
Using display route-policy command, you can view the configured Route-policy
For the related commands, see route-policy.
Example
# Display the information of Route-policy named as policy1.
<Quidway> display route-policy policy1
Route-policy : policy1
Permit 10 : if-match (prefixlist) p1
apply cost 100
matched : 0 denied : 0
Table 5-2 Description of information generated by the command display route-policy
Field Description
Route-policy Name of ip-prefix
Information of the route-policy with mode configured as permit and
node as 10:
if-match
(prefixlist) p1
The configured if-match clause
apply cost 100
Apply routing cost 100 to the routes matching
the conditions defined by if-match clause
matched
Number of routes matching the conditions set
by if-match clause
Permit 10
denied
Number of routes not matching the conditions
set by if-match clause
5.1.11 filter-policy export
Syntax
filter-policy { acl-number | ip-prefix ip-prefix-name } export [ protocol ]
undo filter-policy { acl-number | ip-prefix ip-prefix-name } export [ protocol ]
View
Routing protocol view
To Next Page
Loading...
Need help?
General
