Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-45
3.1.47 snmp-agent trap enable ospf
Syntax
snmp-agent trap enable ospf [ ifstatechange | virifstatechange | nbrstatechange |
virnbrstatechange | ifcfgerror | virifcfgerror | ifauthfail | virifauthfail | ifrxbadpkt |
virifrxbadpkt | txretransmit | viriftxretransmit | originatelsa | maxagelsa |
lsdboverflow | lsdbapproachoverflow ]
undo snmp-agent trap enable ospf [ ifstatechange | virifstatechange |
nbrstatechange | virnbrstatechange | ifcfgerror | virifcfgerror | ifauthfail |
virifauthfail | ifrxbadpkt | virifrxbadpkt | txretransmit | viriftxretransmit |
originatelsa | maxagelsa | lsdboverflow | lsdbapproachoverflow ]
View
System view
Parameter
process-id: Process ID of OSPF. The command is applied to all current OSPF
processes if you do not specify a process ID.
ifstatechange, virifstatechange, nbrstatechange, virnbrstatechange, ifcfgerror,
virifcfgerror, ifauthfail, virifauthfail, ifrxbadpkt, virifrxbadpkt, txretransmit,
viriftxretransmit, originatelsa, maxagelsa, lsdboverflow, lsdbapproachoverflow:
Types of TRAP packets that the switch produces in case of OSPF anomalies.
Description
Using the snmp-agent trap enable ospf command, you can enable the OSPF TRAP
function. Using the undo snmp-agent trap enable ospf command, you can disable
the OSPF TRAP function.
This command cannot be applied to the OSPF processes that are started after the
command is executed.
By default, the switch does not send TRAP packets in case of OSPF anomalies.
For detailed configuration of SNMP TRAP, refer to the module “System Management"
in this manual.
Example
# Enable the TRAP function for OSPF process 100.
[Quidway] snmp-agent trap enable ospf 100
To Next Page
Loading...
Need help?
General
