Command Manual - QoS/ACL
Quidway S3500 Series Ethernet Switches Chapter 2 QoS Commands
Huawei Technologies Proprietary
2-23
If you do not input the port parameters, the command will display the outgoing line rate
settings on the port. If you set the port parameters, the configuration information about
the specified port will be displayed. The information displayed includes egress port and
the line rate.
Example
# Display the line rate settings on the port.
[Quidway-Ethernet0/4] display qos-interface line-rate
Ethernet0/2: line-rate
Line rate: 3 Mbps
Ethernet0/4: line-rate
Line rate: 5 Mbps
Table 2-14 the display Information
Field Description
Ethernet0/2: line-rate
Line rate: 3 Mbps
Indicates the line-rate configuration of the port.
“Line rate: 3 Mbps” indicates the general packet sending
rate on a port.
2.2.9 display qos-interface traffic-limit
Syntax
display qos-interface [ interface-name | interface-type interface-num ] traffic-limit
View
Any view
Parameter
interface-name | interface-type interface-num: Specifies a port of the switch. For
detailed information, refer to the port command manual.
Description
Using display qos-interface traffic-limit command, you can view the settings of traffic
limit.
If you do not input the port parameters, the command will display the traffic limit settings
on the switch. If you set the port parameters, the configuration information about the
specified port will be displayed. The information displayed includes the ACL of the
traffic to be limited, the limited average rate and the settings of some related policing
action.
For the related command, see traffic-limit.
To Next Page
Loading...
Need help?
General
