Command Manual - STP
Quidway S3500 Series Ethernet Switches Chapter 1 MSTP Configuration Commands
Huawei Technologies Proprietary
1-33
2 * (Forward Delay - 1.0 seconds) >= Max Age
Max Age >= 2 * (Hello Time + 1.0 seconds)
Only if the above-mentioned formulas are equal can the MSTP normally operate on the
entire network, otherwise, the network may flap frequently. You are recommended to
use the stp root primary command to specify the diameter of the switching network,
so that MSTP can automatically calculate and give the moderate values for the time
parameters.
For the related command, see stp timer hello, stp timer max-age, stp
bridge-diameter.
Example
# Set the Forward Delay of the device to 2000 centiseconds.
[Quidway] stp timer forward-delay 2000
1.1.36 stp timer hello
Syntax
stp timer hello centi-senconds
undo stp timer hello
View
System view
Parameter
centi-senconds: Specifies Hello Time value with an integer in the range of 100 to 1000
in units of centiseconds. By default, the Hello Time of the switch is 200 centiseconds.
Description
Using stp timer hello command, you can configure Hello Time of the switch. Using
undo stp timer hello command, you can restore the default Hello Time.
The STP defines to transmit configuration BPDU regularly at an interval specified with
Hello Time to keep the spanning tree stable. If the switch receives no BPDU packets
for a period of time, it will recalculate the spanning tree upon the BPDU timeouts. The
root bridge transmits BPDU packets at an interval as you configured, while other
switches apply the Hello Time configured on the root bridge.
When configuring Hello time, Forward Delay and Max Age, remember to guarantee the
following equations:
2 * (Forward Delay -1.0 seconds) >= Max Age
Max Age >= 2 * (Hello Time + 1.0 seconds)
To Next Page
Loading...
Need help?
General
