Command Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 2 Portal Configuration Commands
Huawei Technologies Proprietary
2-10
Caution:
z In the re-DHCP authentication mode, the IP address of an authentication-free user
and the primary IP address of the VLAN interface must be in the same network
segment. In the direct authentication mode, the IP address of an authentication-free
user and the primary IP address of the VLAN interface must be in the same network
segment.
z This configuration takes effect only if the Portal is enabled in the VLAN where the
authentication-free user locates.
z Layer 3 Portal authentication does not support the configurations of
authentication-free users.
Example
# Configure Portal authentication-free users.
[Quidway] portal free-user mac 00e0-fc01-0101 ip 10.110.1.1 vlan 10 interface
ethernet 0/1
2.1.9 portal method
Syntax
portal method { direct | redhcp | layer3 }
undo portal method
View
System view
Parameter
direct: Direct authentication.
redhcp: Re-DHCP authentication.
layer3: Layer 3 Portal authentication, that is, Portal authentication across layer 3.
Description
Use the portal method command to specify authentication mode for Portal.
Use the undo portal method command to restore the default authentication mode.
By default, direct authentication is selected.
Example
# Set Portal authentication to redhcp.
To Next Page
Loading...
Need help?
General
