Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 6 Route Capacity Configuration Commands
Huawei Technologies Proprietary
6-2
6.1.2 display memory limit
Syntax
display memory limit
Mode
Any view
Parameter
None
Description
Using display memory limit command, you can view the memory setting and state
information related to the Ethernet switch capacity, including available memory and
state information about connections such as times for disconnecting connections,
times for reestablishing connections and whether or not the current system is in the
emergent state.
Example
# Display the current memory setting and state information.
<Quidway> display memory limit
Current memory limit configuration information:
system memory safety: 4 (MBytes)
system memory limit: 2 (MBytes)
auto-establish enabled
Free Memory: 14798060 (Bytes)
The state information about connection:
The times of disconnect: 0
The times of reconnect: 0
The current state: Normal
The information displayed by this command includes the Ethernet switch memory limit,
the size of the idle memory, the times of the connection disconnecting, the times of the
connection reestablishment and the current state.
The displayed information is described specifically in the following table:
To Next Page
Loading...
Need help?
General
