Command Manual - QoS/ACL
Quidway S3500 Series Ethernet Switches Chapter 2 QoS Commands
Huawei Technologies Proprietary
2-22
Ethernet0/2: traffic-limit
Inbound:
Matches: acl 2000 rule 0 running
Target rate: 4 Mbps
Exceed action: drop
Ethernet0/2: line-rate
Line rate: 3 Mbps
Ethernet0/4: line-rate
Line rate: 5 Mbps
Table 2-13 the display Information
Field Description
Ethernet0/2: traffic-limit
Inbound:
Matches: acl 1 rule 0
running
Target rate: 4 Mbps
Exceed action: drop
Indicates the traffic-limit configuration of the port.
“Inbound:” indicates system only treats the traffic
received by the port.
“Matches: acl 2000 rule 0 running” indicates the
classification rule to the traffic.
“Target rate: 4 Mbps” indicates the s the normal rate for
the packets matching the classification rule.
“Exceed action: drop” indicates the action to the traffic
which match the classification rule but exceed the
normal rate. The action can be “drop” or “remark-dscp”.
Ethernet0/2: line-rate
Line rate: 3 Mbps
Indicates the line-rate configuration of the port.
“Line rate: 3 Mbps” indicates the general packet sending
rate on a port.
2.2.8 display qos-interface line-rate
Syntax
display qos-interface [ interface-name | interface-type interface-num ] line-rate
View
Any view
Parameter
interface-name | interface-type interface-num: Specifies a port of the switch. For
detailed information, refer to the port command manual.
Description
Using display qos-interface line-rate command, you can view the settings of
outgoing line rate on the port.
To Next Page
Loading...
Need help?
General
