Command Manual - Integrated Management
Quidway S3500 Series Ethernet Switches Chapter 2 HGMP V2 Configuration Commands
Huawei Technologies Proprietary
2-6
will discard the received NDP neighbor node information. Using undo timer aging
command, you can restore the default NDP information aging time.
A user can specify how long an adjacent device will hold the information of the local
device. The adjacent device learns how long it will hold the NDP information from the
aging time carried in NDP packets and discards the packets when the aging timer
expires.
Normally NDP aging time is longer than NDP packet interface. Otherwise, the neighbor
information table of an NDP port will become unstable.
Example
# Configure the aging time of NDP packet as 60, so that an adjacent device will discard
the NDP packets from the local device 60 seconds after receiving them.
[Quidway] ndp timer aging 60
2.1.5 reset ndp statistics
Syntax
reset ndp statistics [ interface port-list ]
View
User view
Parameter
interface port-list Specifies a list of ports isolated from the specified port. A list may
contain consecutive or separated ports, or the combination of consecutive and
separated ports. The parameter is expressed as { interface_type interface_num |
interface_name } [ to { interface_type interface_num | interface_name } ] } &<1-10>.
interface_type specifies the port type. interface_num specifies the port number,
expressed as slot number/port number. Key word to helps specify a port range.
Description
Using reset ndp statistics command, you can reset the NDP counters to clear the
NDP statistics information.
Example
# Clear NDP statistics information.
<Quidway> reset ndp statistics
To Next Page
Loading...
Need help?
General
