Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 4 BGP Configuration Commands
Huawei Technologies Proprietary
4-48
[Quidway-bgp] timer keep-alive 30 hold 90
4.1.60 undo synchronization
Syntax
undo synchronization
View
BGP view
Parameter
None
Description
Using undo synchronization command, you can cancel the synchronization of BGP
and IGP.
By default, BGP doesn’t synchronize with IGP.
If the local BGP is not set synchronous with the IGP and the next hop of the learned
BGP route is reachable, the local BGP will add this BGP route into its routing table
immediately after it learns the route, rather than waiting till the IGP also learns the
route.
This command means BGP does not synchronize with IGP in current system. You need
not configure it for S3500 Series Ethernet Switches don’t support synchronization of
BGP and IGP at present.
Example
# Cancel the synchronization of BGP and IGP.
[Quidway-bgp] undo synchronization
To Next Page
Loading...
Need help?
General
