Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-12
View
Interface view
Parameter
None
Description
Using rip input command, you can allow an interface to receive RIP packets. Using
undo rip input command, you can disable an interface to receive RIP packets.
By default, all interfaces except loopback interfaces are enabled to receive RIP
packets.
This command is used in cooperation with the other two commands: rip output and rip
work . Functionally, rip work is equivalent to rip input & rip output. The latter two
control the receipt and the transmission of RIP packets respectively on an interface.
The former command equals the functional combination of the latter two commands.
For the related commands, see rip output, rip work .
Example
# Specify Vlan-interface 1 not to receive RIP packets.
[Quidway-Vlan-interface1] undo rip input
2.1.15 rip metricin
Syntax
rip metricin value
undo rip metricin
View
Interface view
Parameter
value: Additional route metric added when receiving a packet, ranging from 0 to 16. By
default, the value is 0.
Description
Using rip metricin command, you can configure the additional route metric added to
the route when an interface receives RIP packets. Using undo rip metricin command,
you can restore the default value of this additional route metric.
For the related commands, see rip metricout.
To Next Page
Loading...
Need help?
General
