Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 1 Static Route Configuration Commands
Huawei Technologies Proprietary
1-11
Example
# Display all direct connection routes summary.
<Quidway> display ip routing-table protocol direct
DIRECT Routing tables:
Summary count: 8
DIRECT Routing table status:<active>:
Summary count: 7
Destination/Mask Protocol Pre Cost Nexthop Interface
10.5.1.0/24 DIRECT 0 0 10.5.1.5 Vlan-interface105
10.5.1.5/32 DIRECT 0 0 127.0.0.1 InLoopBack0
100.100.1.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
102.1.1.0/24 DIRECT 0 0 102.1.1.1 LoopBack1
102.1.1.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
127.0.0.0/8 DIRECT 0 0 127.0.0.1 InLoopBack0
127.0.0.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
DIRECT Routing table status:<inactive>:
Summary count: 1
Destination/Mask Protocol Pre Cost Nexthop Interface
100.100.1.1/32 DIRECT 0 0 100.100.1.1 LoopBack0
# View the static routing table.
<Quidway> display ip routing-table protocol static
STATIC Routing tables:
Summary count: 1
STATIC Routing tables status:<active>:
Summary count: 0
STATIC Routing tables status:<inactive>:
Summary count: 1
Destination/Mask Protocol Pre Cost Nexthop Interface
1.2.3.0/24 STATIC 60 0 1.2.4.5 Vlan-interface10
For detailed description of the output information, see Table 1-1.
1.1.7 display ip routing-table radix
Syntax
display ip routing-table radix
View
Any view
Parameter
None
To Next Page
Loading...
