Command Manual - Port
Quidway S3500 Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-21
Parameter
10: The speed on the port is 10Mbps.
100: The speed on the port is 100Mbps.
1000: The speed on the port is 1000Mbps.
auto: The port speed is in peer auto-negotiation status.
Description
Using speed command, you can configure the port speed. Using undo speed
command, you can restore the default speed.
By default, the speed is auto.
For the related command, see duplex.
Example
# Configure Ethernet port Ethernet0/1 port speed as 10Mbps.
[Quidway-Ethernet0/1] speed 10
1.1.27 virtual-cable-test
Syntax
virtual-cable-test
View
Ethernet port view
Parameter
None
Description
Using virtual-cable-test command, you can get the information of the cable test in 5
seconds. The test information includes the condition of the cable ( open or short ) , and
the distance between the ethernet port and the cable with fault.
Note that S3552G/S3552P/S3528G/S3528P/S3552F Ethernet Switches support this
configuration in S3500 series switches.
Example
# Display the information of the cable test.
[Quidway-Ethernet0/1] virtual-cable-test
Cable pair: RX Status:Open Cable Error lenth:5 metres
Cable pair: TX Status:Open Cable Error lenth:5 metres
To Next Page
Loading...
Need help?
General
