Command Manual - Integrated Management
Quidway S3500 Series Ethernet Switches Chapter 2 HGMP V2 Configuration Commands
Huawei Technologies Proprietary
2-28
Parameter
ip-address: IP address of logging host configured for the cluster.
Description
Using logging-host command, you can configure a public logging host for the member
devices on the administrator device. Using undo logging-host command, you can
cancel the logging host.
By default, there is no public logging host configured.
The commands are used to assign an IP address for the logging host of the cluster,
thereby the members can send log information to logging host via the administrator
device.
Example
# Configure the IP address of the logging host on the administrator device.
[Huawei_0.Quidway-cluster] logging-host 1.0.0.9
2.3.16 port-tagged
Syntax
port-tagged vlan vlanid
undo port-tagged
View
Cluster view
Parameter
vlanid: ID of management VLAN, which can be configured as 1 only.
Description
Using port-tagged command, you can configure VLAN check for the communication
inside a cluster on the administrator device. Using undo port-tagged command, you
can cancel VLAN check for the communication inside a cluster on the administrator
device.
By default, VLAN check is performed.
Example
# Configure VLAN check for the communication inside a cluster.
[Huawei_0.Quidway-cluster] port-tagged vlan 1
To Next Page
Loading...
Need help?
General
