Command Manual - VLAN
Quidway S3500 Series Ethernet Switches Chapter 1 VLAN Configuration Commands
Huawei Technologies Proprietary
1-8
After the VLAN is disabled, the switch will not use VLAN ID during the packet exchange,
thereby losing the isolation function of VLAN domain.
Note that S3526E/S3526C switches support the command in S3500 series switches.
For the related commands, see display vlan.
Example
# Enable the VLAN features of equipment.
[Quidway] vlan enable
1.2 Protocol-Based VLAN Configuration Commands
 Note:
Currently, only Quidway S3552G/S3552P/S3528G/S3528P/S3552F Ethernet
Switches support the protocol-based VLAN configuration.
1.2.1 display protocol-vlan interface
Syntax
display protocol-vlan interface { { interface-type interface-num | interface-name } [ to
{ interface-type interface-num | interface-name } ] | all }
View
Any view
Parameter
{ interface_type interface_num | interface_name } [ to { interface_type interface_num |
interface_name } ]: Specifies ports. You can specify multiple sequential ports with the to
parameter, instead of specifying only one port. interface_name specifies port name, in
the format of interface_name = interface_type interface_num. interface_type specifies
port type and interface_num port number.
all: Displays the protocol information of all ports.
Description
Using the display protocol-vlan interface command, you can view the protocol
information and protocol index configured on the specific port, to which you can refer
when you use the protocol-based VLAN and add/delete a protocol.
For the related commands, see display interface.
To Next Page
Loading...
Need help?
General
