Command Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 3 AAA & RADIUS Protocol Configuration Commands
Huawei Technologies Proprietary
3-27
Description
Using local-server command, you can configure the parameters of local RADIUS
server. Using undo local-server command, you can cancel a local RADIUS server.
RADIUS service, which adopts authentication/authorization/accounting servers to
manage users, is widely used in Quidway series switches. Besides, local
authentication/authorization service is also used in these products and it is called local
RADIUS function, i.e. realize basic RADIUS function on the switch.
Caution:
z When using local RADIUS server function of Huawei, remember the number of UDP
port used for authentication is 1645 and that for accounting is 1646.
z The password configured by this command must be the same as that of the
RADIUS authentication/authorization packet configured by the command key
authentication in RADIUS scheme view.
Quidway series switches support up to 16 local RADIUS authentication servers.
For the related commands, see radius scheme, state and key.
Example
# Set the IP address of local RADIUS authentication server to 10.110.1.2 and the
password to huawei.
[Quidway] local-server nas-ip 10.110.1.2 key huawei
3.2.10 nas-ip
Syntax
nas-ip ip-address
undo nas-ip
View
RADIUS scheme view
Parameter
ip-address: IP address in dotted decimal format.
To Next Page
Loading...
Need help?
General
