Huawei quidway s3526 series

Command Manual - STP
Quidway S3500 Series Ethernet Switches Chapter 1 MSTP Configuration Commands
Huawei Technologies Proprietary
1-22
1.1.22 stp interface loop-protection
Syntax
stp interface interface-list loop-protection
undo stp interface interface-list loop-protection
View
System view
Parameter
interface-list: Ethernet port list, containing multiple Ethernet ports and expressed as
interface _list = { { interface_type interface_num | interface_name } [ to { interface_type
interface_num | interface_name } ] }&<1-10>. For detail descriptions of interface_type,
interface_num and interface_name parameters, refer to the corresponding descriptions
in Port Command Manual. &<1-10> means that the preceding parameters can be
entered up to 10 times.
Description
Using stp interface loop-protection command, you can enable loop protection on the
switch in system view. Using undo stp interface loop-protection command, you can
restore the default loop protection state.
By default, loop protection is disabled.
For the related command, see stp loop-protection.
Example
# Enable loop protection on the Ethernet 0/1.
[Quidway] stp interface ethernet 0/1 loop-protection
1.1.23 stp interface mcheck
Syntax
stp interface interface-list mcheck
View
System view
Parameter
interface-list: Ethernet port list, containing multiple Ethernet ports and expressed as
interface _list = { { interface_type interface_num | interface_name } [ to { interface_type
interface_num | interface_name } ] }&<1-10>. For detail descriptions of interface_type,
interface_num and interface_name parameters, refer to the corresponding descriptions