Command Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 4 System Maintenance Commands
Huawei Technologies Proprietary
4-22
channel-name: Specify the channel name. The name can be channel6, channel7,
channel8, channel9, console, logbuffer, loghost, monitor, snmpagent,
trapbuffer.
Description
Using info-center console channel command, you can configure the channel through
which the log information is output to the console.
By default, Ethernet switches do not output log information to the console.
This command takes effect only after system logging is started.
For the related commands, see info-center enable,display info-center.
Example
# Configure to output log information to the console through channel 0.
[Quidway] info-center console channel 0
4.5.5 info-center enable
Syntax
info-center enable
undo info-center enable
View
System view
Parameter
None
Description
Using info-center enable command, you can enable the system log function. Using
undo info-center enable command, you can disable system log function.
By default, system log function is enabled.
Only after the system log function is enabled can the system output the log information
to the info-center loghost and console, etc.
For the related commands, see info-center loghost, info-center logbuffer,
info-center console channel, info-center monitor channel, display info-center.
Example
# Enable the system log function.
[Quidway] info-center enable
To Next Page
Loading...
Need help?
General
