Command Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 2 MAC Address Table Management Commands
Huawei Technologies Proprietary
2-2
Parameter
mac-addr: Specify the MAC address.
vlan-id: Specify the VLAN ID.
static: Static table entry, lost after resetting switch.
dynamic: Dynamic table entry, which will be aged.
interface-type: Specify the interface type.
interface-num: Specify the interface number.
interface-name: Specify the interface name.
For details about the interface-type, interface-num and interface-name parameters,
refer to the Port Configuration in this manual.
count: the display information will only contain the sum number of MAC addresses in
the MAC address table if user choice this parameter when using this command.
Description
Using display mac-address command, you can view MAC address table information.
When managing the Layer-2 addresses of the switch, the administrator can Perform
this command to view such information as the Layer-2 address table, address status
(static or dynamic), Ethernet port of the MAC address, VLAN of the address, and
system address aging time.
For the related commands, see mac-address, mac-address timer.
Example
# Show the information of the entry with MAC address at 00e0-fc01-0101 on S3526E.
[Quidway] display mac-address 00e0-fc01-0101
MAC ADDR VLAN ID STATE PORT INDEX AGING TIME
00e0-fc01-0101 1 Learned Ethernet0/1 AGING
# Show the information of the entry with MAC address at 00e0-fc01-0101 on S3526.
[Quidway] display mac-address 00e0-fc01-0101
MAC ADDR VLAN ID STATE PORT INDEX AGING TIME(s)
00e0-fc01-0101 1 Learned Ethernet0/1 300
2.1.3 mac-address
Syntax
mac-address { static | dynamic } mac-addr interface { interface-name | interface-type
interface-num } vlan vlan-id
To Next Page
Loading...
Need help?
General
