Command Manual - Integrated Management
Quidway S3500 Series Ethernet Switches Chapter 2 HGMP V2 Configuration Commands
Huawei Technologies Proprietary
2-16
View
Cluster view
Parameter
recover: automatic get back the members of a cluster for the administrator device
when it reboot.
Description
Using auto-build command, you can configure a cluster automatically.
This command can be used on a candidate device or an administrator device.
When you use this command on a candidate device, the system requires you to input a
cluster name and creates a cluster. And then the cluster uses NTDP to collect
candidates and adds them to the cluster upon your confirmation.
When you use this command on an administrator device, the system will collect the
candidates directly.
The recover parameter is used for recover a cluster. Using the auto-build recover
command, you can find the members left the member list and add them to the cluster
again.
Note: Ensure that NTDP is enabled, because it is the basis of candidate and member
collection. The collection range is also decided through NTDP. You can use hop
command to decide the collection range in System view.
If a member has been configured with an enable-password different from the password
of the administrator device, it cannot be added to a cluster automatically.
Example
# Set up a cluster automatically.
[Quidway-cluster] auto-build
2.3.4 build
Syntax
build name
undo build
View
Cluster view
Parameter
name: Cluster name with no more than 8 characters, including and only including
letters, numerals, subtraction sign “-” and underline “_”.
To Next Page
Loading...
Need help?
General
