Huawei quidway s3526 series

Command Manual - Network Protocol
Quidway S3500 Series Ethernet Switches Chapter 9 Access Management Configuration Commands
Huawei Technologies Proprietary
9-5
View
Any view
Parameter
interface-list: Specifies a list of ports isolated from the specified port in the
{ { interface-type interface-number | interface-name } [ to { interface-type
interface-number | interface-name } ] } &<1-10> format. interface-name: Specified the
port name, represented with interface-name= interface-type interface-number.
interface-type is port type and interface-number is port number. For details about
interface-type, interface-number and interface-name, refer to the Port Command
Manual. &<1-10> indicates the preceding parameter can be input up to 10 times.
Description
Using display am command, you can view the current access management
configurations on part or all of the ports.
Example
# Display the access management configurations on Ethernet0/1 and Ethernet0/2.
<Quidway> display am ethernet0/1 ethernet0/2
Ethernet0/1
Status : disabled
IP Pools : (NULL)
Isolate Ports: Ethernet0/2
Ethernet0/2
Status : disabled
IP Pools : (NULL)
Isolate Ports: Ethernet0/1
Table 9-1 Description of information generated by the command display am
Field Description
Ethernet Port to be displayed
Status AM state on the port: enabled or disabled
IP Pools
IP pools. NULL represents no configuration. Each IP address
section is represented in X.X.X.X (number), of these, “X.X.X.X”
represents the first address, and “number” represents that
“number” consecutive IP addresses from the beginning of this
address are within the IP pools
Isolate Ports Isolate ports. NULL represents no configuration