Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Table of Contents
Huawei Technologies Proprietary
v
5.1.11 filter-policy export.................................................................................................. 5-8
5.1.12 filter-policy import.................................................................................................. 5-9
5.1.13 if-match { acl | ip-prefix }...................................................................................... 5-10
5.1.14 if-match as-path .................................................................................................. 5-11
5.1.15 if-match community............................................................................................. 5-12
5.1.16 if-match cost........................................................................................................ 5-12
5.1.17 if-match interface................................................................................................. 5-13
5.1.18 if-match ip next-hop............................................................................................. 5-14
5.1.19 if-match tag.......................................................................................................... 5-15
5.1.20 ip ip-prefix............................................................................................................ 5-15
5.1.21 route-policy.......................................................................................................... 5-16
Chapter 6 Route Capacity Configuration Commands ............................................................... 6-1
6.1 Route Capacity Configuration Commands ........................................................................ 6-1
6.1.1 display memory....................................................................................................... 6-1
6.1.2 display memory limit................................................................................................ 6-2
6.1.3 memory auto-establish disable ............................................................................... 6-3
6.1.4 memory auto-establish enable................................................................................ 6-4
6.1.5 memory { safety | limit }........................................................................................... 6-4