Huawei quidway s3526 series

Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 1 Static Route Configuration Commands
Huawei Technologies Proprietary
1-7
# There is no corresponding route (only the longest matching route is displayed) in
natural mask range and summary is displayed.
<Quidway> display ip routing-table 169.253.0.0
Destination/Mask Protocol Pre Cost Nexthop Interface
169.0.0.0/8 Static 60 0 2.1.1.1 LoopBack1
# There are corresponding routes in the natural mask range. Display the detailed
information.
<Quidway> display ip routing-table 169.0.0.0 verbose
Routing Tables:
Generate Default: no
+ = Active Route, - = Last Active, # = Both * = Next hop in use
Summary count:2
**Destination: 169.0.0.0 Mask: 255.0.0.0
Protocol: #Static Preference: 60
*NextHop: 2.1.1.1 Interface: 2.1.1.1(LoopBack1)
Vlinkindex: 0
State: <Int ActiveU Static Unicast>
Age: 3:47 Cost: 0/0
**Destination: 169.0.0.0 Mask: 255.254.0.0
Protocol: #Static Preference: 60
*NextHop: 2.1.1.1 Interface: 2.1.1.1(LoopBack1)
Vlinkindex: 0
State: <Int ActiveU Static Unicast>
Age: 3:47 Cost: 0/0
# There are no corresponding routes in the natural mask range (only displaying the
longest matched route). Display the detailed information.
<Quidway> display ip routing-table 169.253.0.0 verbose
Routing Tables:
Generate Default: no
+ = Active Route, - = Last Active, # = Both * = Next hop in use
Summary count:2
**Destination: 169.0.0.0 Mask: 255.0.0.0
Protocol: #Static Preference: 60
*NextHop: 2.1.1.1 Interface: 2.1.1.1(LoopBack1)
Vlinkindex: 0
State: <Int ActiveU Static Unicast>
Age: 3:47 Cost: 0/0
**Destination: 169.0.0.0 Mask: 255.254.0.0
Protocol: #Static Preference: 60
*NextHop: 2.1.1.1 Interface: 2.1.1.1(LoopBack1)
Vlinkindex: 0