Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 5 IP Routing Policy Configuration Commands
Huawei Technologies Proprietary
5-17
View
System view
Parameter
route-policy-name: Specify the Route-policy name to identify one Route-policy
uniquely.
permit: Specify the match mode of the defined Route-policy node as permit mode.
deny: Specify the match mode of the defined Route-policy node as deny mode.
node: Node of the route policy.
node-number: Index of the node in the route-policy. When this route-policy is used for
routing information filtration, the node with smaller node-number will be tested first.
Description
Using route-policy command, you can create and enter the Route-policy view. Using
undo route-policy command, you can delete the established Route-policy.
By default, no Route-policy is defined.
Route-policy is used for route information filtration or route policy. One Route-policy
comprises of some nodes and each node comprises of some match and apply
sub-statements. The if-match sub-statement defines the match rules of this node and
the apply sub-statement defines the actions after passing the filtration of this node. The
filtering relationship between the if-match sub-statements of the node is “and”, i.e., all
if-match sub-statements that meet the node. The filtering relation between Route-policy
nodes is "OR", i.e. passing the filtering of one node means passing the filtering of this
Route-policy. If the information doesn’t pass the filtration of any nodes, it cannot pass
the filtration of this Route-policy.
For the related commands, see if-match interface, if-match acl, if-match ip-prefix,
if-match ip next-hop, if-match cost, if-match tag, apply ip next-hop, apply
local-preference, apply cost, apply origin and apply tag.
Example
# Configured one Route-policy policy1, whose node number is 10 and if-match mode is
permit, and enter Route policy view.
[Quidway] route-policy policy1 permit node 10
[Quidway-route-policy]
To Next Page
Loading...
Need help?
General
