EasyManuals Logo

Huawei quidway s3526 series User Manual

Huawei quidway s3526 series
894 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #504 background imageLoading...
Page #504 background image
Command Manual - QoS/ACL
Quidway S3500 Series Ethernet Switches Chapter 2 QoS Commands
Huawei Technologies Proprietary
2-63
remark-drop-priority: Sets drop precedence based on conform-level.
remark-policed-service: Sets service groups based on conform-level and DSCP
priority.
exceed: Chooses action for over-threshold traffic, optional parameter.
z forward: Forwards packets.
z drop: Drops packets.
Description
Using the traffic-limit command, you can enable the ACL, initiate traffic limit and
specify different actions for in-threshold and over-threshold packets. Using the undo
traffic-limit command, you can remove traffic limit setting.
This configuration is only available to the permitted rules.
When setting the parameters of traffic policing, the following rule is recommended:
cir<pir, cbs=ebs=(cir/8)*(1~1.5). For example, if cir is set 1000Kbps, cbs=ebs
=(1000/8)*(1~1.5)= (125~180)Kbytes=(125000~180000)bytes. Note that, the
parameter unit of cbs and ebs is byte.
Note:
If you choose untrusted mode for a specific traffic in traffic-priority operation, that is,
you manually specify a service group for the designated traffic, then the traffic-limit
and traffic-statistic operations are invalid for this traffic. If you choose traffic-limit and
traffic-statistic, however, then the untrusted mode is invalid.
To the same data traffic, you cannot set both remark-cos and remark-policed-service
or both remark-drop-priority and remark-policed-service.
If you want to initiate remark-policed-service or remark-cos action, you must ensure
you have configured “DSCP+Conform-Level Service group” mapping table or
“TC+Conform-Level 802.1p priority” mapping table. For more information about
these two mapping tables, see the qos conform-level, dscp and local-precedence
commands.
Example
# Initiate traffic limit on the packets match the permitted rules in ACL 4000, the detailed
setting: CIR is 200 kbps; CBS is 25000 bytes; EBS is 25000bytes; drop the
over-threshold packets.
[Quidway-Ethernet0/1] traffic-limit inbound link-group 4000 200 25000 25000
conform remark-policed-service exceed-action drop

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei quidway s3526 series and is the answer not in the manual?

Huawei quidway s3526 series Specifications

General IconGeneral
BrandHuawei
Modelquidway s3526 series
CategoryNetwork Router
LanguageEnglish

Related product manuals