Command Manual - Integrated Management
Quidway S3500 Series Ethernet Switches Chapter 1 Stack Function Configuration Commands
Huawei Technologies Proprietary
1-4
View
System view
Parameter
from-ip-address: Starting address of the stack IP address pool.
ip-address-number: Number of IP address in the stack IP addresses pool.
ip-mask: Mask of the stack IP address.
Description
Using stacking ip-pool command, you can configure the optional IP address range in
public network for a stack. Using undo stacking ip-pool command, you can restore to
the default IP address configuration of the stack.
By default, no IP pool is configured.
Before establishing a stack, the user should firstly set the optional IP address range in
the public network for a stack. Then the master switch will automatically distribute the
applicable IP addresses for the slave switches to add to the stack.
This command can only be used on the non-stack switches. After a stack is
established, the user will not be able to modify its IP address range.
ip-address-number must be larger than or equal to the maximum-number of stack
switches. Otherwise, some switches cannot be added into the stack automatically.
Example
# Set the optional IP address range in public network for a stack.
[Quidway] stacking ip-pool 129.10.1.1 5
To Next Page
Loading...
Need help?
General
