Huawei quidway s3526 series

Command Manual - Integrated Management
Quidway S3500 Series Ethernet Switches Chapter 2 HGMP V2 Configuration Commands
Huawei Technologies Proprietary
2-3
Interface: Ethernet0/19
Status: Enabled, Pkts Snd: 0, Pkts Rvd: 0, Pkts Err: 0
Interface: Ethernet0/20
Status: Enabled, Pkts Snd: 0, Pkts Rvd: 0, Pkts Err: 0
Interface: Ethernet0/21
Status: Enabled, Pkts Snd: 0, Pkts Rvd: 0, Pkts Err: 0
Interface: Ethernet0/22
Status: Enabled, Pkts Snd: 0, Pkts Rvd: 0, Pkts Err: 0
Interface: Ethernet0/23
Status: Enabled, Pkts Snd: 11, Pkts Rvd: 12, Pkts Err: 0
Neighbor 1: Aging Time: 170(s)
MAC Address : 00e0-fc00-0003
Port Name : Ethernet0/23
Software Ver: VRP3.10
Device Name : Quidway S3526
Port Duplex : AUTO
Product Ver : 3526-0001C
Interface: Ethernet0/24
Status: Enabled, Pkts Snd: 0, Pkts Rvd: 0, Pkts Err: 0
Interface: GigabitEthernet2/1
Status: Enabled, Pkts Snd: 4, Pkts Rvd: 5, Pkts Err: 0
Table 2-1 Information about NDP configuration the NDP neighbors discovered by a
port
Field Description
Neighbor Discovery
Protocol is enabled
The system NDP is enabled on the switch
Neighbor Discovery
Protocol Ver: 1
The NDP version
Hello Timer: 60(s)
The current device transmits NDP packet every 60
seconds.
Aging Timer: 180(s)
A neighbor keeps the NDP information of the current
device for 180 seconds.
Interface: Ethernet0/1 Port number, specify a port
Status: Enabled NDP is enabled on the port