Command Manual - STP
Quidway S3500 Series Ethernet Switches Chapter 1 MSTP Configuration Commands
Huawei Technologies Proprietary
1-2
View
MST region view
Parameter
None
Description
Using check region-configuration command, you can view the configuration
information (including switch region name, revision level, and VLAN mapping table) to
be activated.
MSTP defines that the user must ensure the correct region configurations, especially
the VLAN mapping table configuration. The switches can be configured in the same
region only if their region names, VLAN mapping tables, and MSTP revision levels are
configured exactly the same. The switch may not be configured in the expected region
due to any slight deviation. You can use this command to display the MST region
configuration information to be activated to know to which MST regions the switch
belongs and check if the MST region configurations are correct.
For the related command, see instance, region-name, revision-level, vlan-mapping
modulo, active region-configuration .
Example
# Display the configuration information about the region.
[Quidway-mst-region] check region-configuration
Admin. Configuration:
Format selector :0
Region name :00b010000001
Revision level :0
Instance Vlans Mapped
0 1 to 9, 11 to 4094
16 10
Table 1-1 the display Information
Field Description
Format selector Factor to selelct protocol type prescribed in MSTP
Region name Region name of MST region
Revision level MSTP revision level of MST region
Instance Vlans Mapped VLAN mapping table of MST region
To Next Page
Loading...
Need help?
General
