Command Manual - STP
Quidway S3500 Series Ethernet Switches Chapter 1 MSTP Configuration Commands
Huawei Technologies Proprietary
1-8
The spanning tree statistics information includes TCN, Config BPDU, RST, and MST
BPDU, received and transmitted on the port. Among them, STP BPDU and TCN BPDU
are counted on CIST.
When the spanning tree ID and port list are specified, the command clears the statistics
information of the specified spanning tree on the specified port. If no port is specified,
the command clears the statistics information of the specified spanning tree on all the
ports. If no spanning tree is specified, the command clears the statistics information of
all the spanning trees.
For the related command, see display stp.
Example
# Clear the statistics information on the ports from Ethernet0/1 through Ethernet0/3.
<Quidway> reset stp interface ethernet0/1 to ethernet0/3
1.1.8 revision-level
Syntax
revision-level level
undo revision-level
View
MST region view
Parameter
level: Specifies the MSTP revision level, ranging from 0 to 65535. By default, MSTP
revision level takes 0.
Description
Using revision-level command, you can configure MSTP revision level of the switch.
Using undo revision-level command, you can restore the default revision-level .
MSTP revision level, together with region name and VLAN mapping table, is used for
determining the MST region to which the switch belongs.
For the related command, see instance, region-name, check region-configuration ,
vlan-mapping modulo and active region-configuration .
Example
# Set the MSTP revision level of the switch MST region to 5.
[Quidway-mst-region] revision-level 5
To Next Page
Loading...
Need help?
General
