Command Manual - Port
Quidway S3500 Series Ethernet Switches Chapter 3 Port Isolation Configuration Commands
Huawei Technologies Proprietary
3-2
View
Ethernet port view
Parameter
vlan-id: VLAN the uplink port belong to, in the range of 1 to 4094.
Description
Using port-isolate uplink-port vlan command, you can configure an isolated port as
uplink port. Using undo port-isolate uplink-port vlan command, you can restore the
uplink port to common isolated port.
By default, no uplink port is configured.
Note that:
z After port L2 isolation is enabled in a VLAN, then you are allowed to configure a
port as uplink port. You can only configure one uplink port in a VLAN.
z You must first restore the uplink port to common isolated port before deleting it
from the VLAN.
z If a Trunk port is set as uplink port, then you are recommended to set that all VLAN
are allowed to pass through the Trunk port and that it is the only uplink port in that
VLAN.
z You cannot enable port isolation and link aggregation concurrently on a port.
Example
# Configure the Ethernet0/1 port as uplink port.
[Quidway-Ethernet0/1] port-isolate uplink-port vlan 1
To Next Page
Loading...
Need help?
General
