Command Manual - Auto Detecting
Quidway S3500 Series Ethernet Switches Chapter 1 Auto Detect Configuration Commands
Huawei Technologies Proprietary
1-3
Description
Use the display detect-group command to display configuration information about a
specified detecting group or all detecting groups.
Example
# Display configuration information about detecting group 1.
[Quidway] display detect-group 1
detect-group 1 :
detect loop time(s): 15
ping wait time(s): 2
detect retry times: 2
detect ip option: and
group state: not detecting
register module num: 0
detect ip number: 1
detect-list ip address next-hop
1 1.1.1.1 1.1.1.5
Table 1-1 Description on the fields of the display detect-group command
Field Description
detect-group 1 Detecting group 1
detect loop time(s): 15 The detecting interval is 15 seconds.
ping wait time(s): 2 The timeout time is 2 seconds.
detect retry times: 2 The retry times is 2.
detect ip option: and
The detecting result is reachable only when all the
specified interfaces can be successfully pinged.
group state: not
detecting
The detecting group is not in use at present.
register module num: 0 Count of times the detect group has been referenced.
detect ip number: 1
Number of IP addresses contained in the detecting
group.
detect-list
The number of an IP address contained in the
detecting group.
ip address The IP address of the interface to be detected.
next-hop The IP address of the interface taken as the next hop.
To Next Page
Loading...
Need help?
General
