NXP Semiconductors PXN2020 - 8.3.2.12 IRQ Filtered Input Register (SIU_IFIR); 8.3.2.13 Pad Configuration Registers (SIU_PCR)

System Integration Unit (SIU)
PXN20 Microcontroller Reference Manual, Rev. 1
8-22 Freescale Semiconductor
8.3.2.12 IRQ Filtered Input Register (SIU_IFIR)
This is a read-only register that captures the output of the NMIn and IRQn digital input filters.
8.3.2.13 Pad Configuration Registers (SIU_PCR)
The following subsections define the SIU_PCRs for all device pins that allow configuration of the pin
function, direction, and static electrical attributes. The information presented pertains to which bits and
fields are active for a given pin or group of pins, and the register reset state. The reset state of SIU_PCRs
in the following sections is prior to executing the boot-assist module (BAM) program. The BAM program
may change SIU_PCRs based on reset configuration. See the BAM section of the manual for more detail.
For all SIU_PCRs:
Table 8-14. SIU_IDFR Field Descriptions
Field Function
DFL
Digital Filter Length. Defines digital filter period on the IRQn inputs according to the following equation:
For a 116 MHz system clock, this gives a range of 15.6 ns to 256 s. The minimum time of two clocks accounts for
synchronization of the IRQ input pins with the system clock.
Offset: SIU_BASE + 0x0034 Access: User read only
0123456789101112131415
R FNMI0 FNMI1 00000000000000
W
Reset0000000000000000
16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31
R FI15 FI14 FI13 FI12 IFI11 FI10 FI9 FI8 FI7 FI6 FI5 FI4 FI3 FI2 FI1 FI0
W
Reset0000000000000000
Figure 8-13. External IRQ Filtered Input Register (SIU_IFIR)
Table 8-15. SIU_IFIR Field Descriptions
Field Function
FNMI0 Filtered Non-Maskable Interrupt 0. This bit is set/cleared for the corresponding NMI pin:
0 A logic one has passed through the NMI digital filter for NMI0 pin.
1 A logic zero has passed through the NMI digital filter for NMI0 pin.
FNMI1 Filtered Non-Maskable Interrupt 1. This bit is set/cleared for the corresponding NMI pin:
0 A logic one has passed through the NMI digital filter for NMI1 pin.
1 A logic zero has passed through the NMI digital filter for NMI1 pin.
FIn Filtered Input n. This bit is set/cleared for the corresponding filtered IRQ pin:
0 A logic one has passed through the IRQ digital filter for the corresponding IRQ pin.
1 A logic zero has passed through the IRQ digital filter for the corresponding IRQ pin.
Filter Period SystemClockPeriod 2
DFL
1S ystemClockPeriod+=