April, 2007 ADDITIONAL INFORMATIONS
4-97
6. Change the Fusing Temperature settings according to the type of "Middle
Thickness Paper Mode", which is most appropriate for the poor fusing symptom.
1) "Middle Thickness Paper Mode -1" (Default)
NOTE: This setting is effective both for poor fusing and the sponge image /
stripper streaks. You do NOT have to change any SP settings (Default
settings are OK).
• SP1105-013 (Htg Roll Sn1: Ctr / 1-S: Thk3: FC: NS: CPM)
Default: 180.
• SP1105-021 (Htg Roll Sn1: Ctr / 2-S: Thk3: FC: NS: CPM
Default: 180.
2) "Middle Thickness Paper Mode -2"
NOTE: This setting should be selected if the effectiveness of "Middle
Thickness Paper Mode-1" is not enough for the poor fusing. However,
with this setting, it is easier for stripper streaks to occur.
Change the following SP setting as a set.
• SP1105-013 (Htg Roll Sn1: Ctr / 1-S: Thk3: FC: NS: CPM)
Change to 185 (default: 180)
• SP1105-021 (Htg Roll Sn1: Ctr / 2-S: Thk3: FC: NS: CPM
Change to 185 (default: 180)
3) "Middle Thickness Paper Mode -3"
NOTE: This setting should be selected if the effectiveness of "Middle
Thickness Paper Mode-2" is still not enough for the poor fusing.
However, with this setting, it is easier for stripper streaks to occur.
Change the following SP setting as a set.
• SP1105-013 (Htg Roll Sn1: Ctr / 1-S: Thk3: FC: NS: CPM)
Change to 190 (default: 180)
• SP1105-021 (Htg Roll Sn1: Ctr / 2-S: Thk3: FC: NS: CPM)
Change to 190 (default: 180)
• SP1107-001 (Mode Shift Low Temp SW)
Change to 0 (default: 5)
To Next Page
Loading...
