Toshiba e-STUDIO4500c - Page 626

SERVICE PROGRAM TABLES August, 2006
5-134
6102
Adj Punch Pos 2
Punch Position Adjustment
Adjusts the punch position perpendicular to the direction of feed.
[-20~+20/0.4 mm]
+ Value: Shifts punch unit toward back of the finisher.
- Value: Shift punch unit toward front of the finisher.
001
2-Hole:DOM
002
3-Hole:NA
003
4-Hole:EU
004
4-Hole:SCAN
005
2-Hole:NA
Paper Feed
B132S922.WMF
6103
Punch Hole Reg 1 Punch Hole Registration Adjustment
This SP corrects punch hole alignment by correcting the skew of each by adjusting
the amount of time the finisher entrance roller remains off while the exit roller of the
machine remains on. This buckles the leading edge of the sheet slightly against the
finisher entrance roller while it remains off.
001
A3 SEF [-500~+500/0.3 mm]
002
B4 SEF + Value:Increases time finisher entrance roller remains off.
003
A4 SEF - Value: Descreases time finisher entrance roller remains off.
004
A4 LEF
005
B5 SEF
006
B5 LEF
007
DLT SEF
008
LG SEF
009
LT SEF
010
LT LEF
011
12" x 18"
012
Custom Size