Copper Mountain Technologies S2 Series - Calc:mark:math:flat:dom:stop; Calc:mark:ref

S2VNA and S4VNA SCPI Programming Manual
134
CALC:MARK:MATH:FLAT:DOM:STOP
CALCulate <Ch> [:SELected]:MARKer:MATH:FLATness:STOP <numeric>
CALCulate <Ch> [:SELected]:MARKer:MATH:FLATness:STOP?
Description
Sets or reads out the number of the marker, which specifies the
stop frequency of the FLATNESS function domain.
(command/query)
Target
The active trace of channel <Ch>,
<Ch>={[1]|2|...16}
Parameter
<numeric> marker number from 1 to 16
Query Response
<numeric>
Preset Value
2
Equivalent Softkeys
Markers > Marker Math > Flatness > Flatness Stop
CALC:MARK:REF
CALCulate <Ch> [:SELected]:MARKer:REFerence[:STATe] {OFF|ON|0|1}
CALCulate <Ch> [:SELected]:MARKer:REFerence[:STATe]?
Description
Turns ON/OFF the reference marker.
When the reference marker is turned ON, all the values of the other
markers turn to relative values.
(command/query)
Target
The active trace of channel <Ch>,
<Ch>={[1]|2|...16}
Parameter
{ON|1} : Reference marker ON
{OFF|0} : Reference marker OFF
Query Response
{0|1}
Preset Value
0
Equivalent Softkeys
Markers > Reference Marker