Copper Mountain Technologies S2 Series - Sens:corr:coll:ckit:stan:l3; Sens:corr:coll:ckit:stan:lab

S2VNA and S4VNA SCPI Programming Manual
240
SENS:CORR:COLL:CKIT:STAN:L3
SENSe:CORRection:COLLect:CKIT:STAN <Std> :L3 <numeric>
SENSe:CORRection:COLLect:CKIT:STAN <Std> :L3?
Description
Sets or reads out the L3 value for the short calibration standard.
(command/query)
Target
Standard <Std> of the selected calibration kit,
<Std>={[1]|2|...N}, where N – the number of the standards in
the calibration kit
Parameter
<numeric> the L3 value from –1E18 to 1E18
Unit
1E–42 H/Hz
3
(Henry/Hertz
3
)
Out of Range
Sets the value of the limit, which is closer to the specified value.
Query Response
<numeric>
Equivalent Softkeys
Calibration > Cal Kit > Define STDs > L3 10
–42
H/Hz
3
SENS:CORR:COLL:CKIT:STAN:LAB
SENSe:CORRection:COLLect:CKIT:STAN <Std> :LABel <string>
SENSe:CORRection:COLLect:CKIT:STAN <Std> :LABel?
Description
Sets or reads out the label for the calibration standard.
(command/query)
Target
Standard <Std> of the selected calibration kit,
<Std>={[1]|2|...N}, where N – the number of the standards in
the calibration kit
Parameter
<string>, up to 254 characters
Query Response
<string>
Equivalent Softkeys
Calibration > Cal Kit > Define STDs > Label