Copper Mountain Technologies S2 Series - Sens:freq: Stop

S2VNA and S4VNA SCPI Programming Manual
317
SENS:FREQ: STOP
SENSe <Ch> :FREQuency:STOP <frequency>
SENSe <Ch> :FREQuency:STOP?
Description
Sets or reads out the stimulus stop value of the sweep range for
linear or logarithmic sweep type.
(command/query)
Target
Channel <Ch>,
<Ch>={[1]|2|...16}
Parameter
<frequency> the stimulus stop value within the frequency limits of the
analyzer..
Unit
Hz (Hertz)
Out of Range
Sets the value of the limit, which is closer to the specified value.
Query Response
<numeric>
Preset Value
The maximum frequency limit of the analyzer.
Equivalent Softkeys
Stimulus > Stop