Copper Mountain Technologies S2 Series - Sens:corr:offs:coll:thru

S2VNA and S4VNA SCPI Programming Manual
300
SENS:CORR:OFFS:COLL:THRU
SENSe <Ch> :CORRection:OFFSet:COLLect[:ACQuire]:THRU <numeric1> , <numeric2>
Description
Measures the calibration data of the thru standard of the specified
port when the frequency offset feature is on for scalar mixer
calibration.
(no query)
Target
Channel <Ch>,
<Ch>={[1]|2|...16}
Parameter
<numeric1> Response port number;
<numeric2> Stimulus port number.
Out of Range
If the same port numbers are specified, an error occurs.
Notes
The command starts the measurement immediately if the trigger source
for calibration set to the "Internal" by the command
SENS:CORR:TRIG:FREE, otherwise waits for the trigger signal. The
command blocks the execution of the subsequent commands until the
completion of the measurement.
Equivalent Softkeys
Calibration > Mixer/Converter Calibration > Scalar Mixer Calibration >
Reflection Port n > Port n @Freq m Thru