Copper Mountain Technologies S2 Series - Calc:fsim:send:zcon:port:z0

S2VNA and S4VNA SCPI Programming Manual
70
CALC:FSIM:SEND:ZCON:PORT:Z0
CALCulate <Ch> :FSIMulator:SENDed:ZCONversion:PORT <Pt> :Z0[:R] <numeric>
CALCulate <Ch> :FSIMulator:SENDed:ZCONversion:PORT <Pt> :Z0[:R]?
Description
Sets or reads out the value of the impedance for port impedance
conversion function.
(command/query)
Target
Port <Pt> of channel <Ch>,
<Ch>={[1]|2|...16}
<Pt>={[1]|2} for S2VNA or {[1]|2|3|4} for S4VNA
Parameter
<numeric> the impedance value from 1e–6 to 1e6
Unit
Ω (Ohm)
Out of Range
Sets the value of the limit, which is closer to the specified value.
Query Response
<numeric>
Preset Value
50
Equivalent Softkeys
Analysis > Fixture Simulator > Port Z Conversion > Port n Z0