Copper Mountain Technologies S2 Series - Sens:corr:coll:thru:add:del

S2VNA and S4VNA SCPI Programming Manual
272
SENS:CORR:COLL:THRU:ADD:DEL
SENSe <Ch> :CORRection:COLLect:THRU:ADDition:DELay <numeric>
SENSe <Ch> :CORRection:COLLect:THRU:ADDition:DELay?
Description
Sets or reads out the approximate delay value of an unknown thru
in the thru addition function. This value is used to eliminate the
uncertainty of ± 180 ° when calculating the phase response of the
thru.
If this value is set to zero, the analyzer uses an algorithm to
automatically determine the delay of the thru. In most cases
setting this value to zero is enough. Setting this value to non zero
is required when:
 


(command/query)
Target
Channel <Ch>,
<Ch>={[1]|2|...16}
Parameter
<numeric> the approximate delay value of the thru.
Unit
Seconds
Query Response
<numeric>
Preset Value
0
Note
The delay and the length of the thru can be set mutually.
 




Equivalent Softkeys
Calibration > Calibrate > Thru Addition > Delay