Copper Mountain Technologies S2 Series - Opc

S2VNA and S4VNA SCPI Programming Manual
36
*OPC
*OPC
Description
Sets the OPC bit (bit 0) of the Standard Event Status Register at the
completion of all pending operations.
The pending operation caused by the command TRIG:SING only.
(no query)
Target
Status Reporting System
Equivalent Softkeys
None
*OPC?
*OPC?
Description
Reads out the "1" at the completion of all pending operations. The
query blocks the execution of the user program until execution of
all previous instructions.
The query *OPC? can be used for waiting for the end of a sweep
initiated by the command TRIG:SING.
(query only)
Target
Analyzer
Query Response
1
Related Commands
TRIG:SING
Equivalent Softkeys
None