Turns ON/OFF the continuous trigger initiation mode.
When the continuous initiation mode turned ON:
ï‚· If the Internal trigger source is selected by the command
TRIG:SOUR INT, then the channel continuously sweeps;
ï‚· If the trigger source other than the internal is selected, then
the channel goes to the trigger waiting state. Upon receipt of
a trigger from the selected source, the sweep starts for the
channels awaiting trigger. On completion of the sweep the
channel goes to the trigger waiting state.
When the continuous trigger initiation mode turned OFF the channel
is in the Hold state, to initiate a sweep one should use the INIT
command.
(command /query)
To Next Page
Loading...
Need help?
General