Copper Mountain Technologies S2 Series - Calc:par:sel; Calc:par:spor

S2VNA and S4VNA SCPI Programming Manual
74
CALC:PAR:SEL
CALCulate <Ch> :PARameter <Tr> :SELect
Description
Selects the active trace in channel.
(no query)
Target
Trace <Tr> of channel <Ch>,
<Tr>={[1]|2|...16}
<Ch>={[1]|2|...16}
Notes
If the trace number is greater than the number of the traces displayed in
the channel, an error occurs and the command is ignored.
Related Commands
CALC:PAR:COUN
Equivalent Softkeys
Display > Active Trace/Channel > Active Trace
CALC:PAR:SPOR
CALCulate <Ch> :PARameter <Tr> :SPORt <port>
CALCulate <Ch> :PARameter <Tr> :SPORt?
Description
Sets or reads out the number of the stimulus port, when
performing absolute measurements.
(command/query)
Target
Trace <Tr> of channel <Ch>,
<Tr>={[1]|2|...16}
<Ch>={[1]|2|...16}
Parameter
<port> the number of the stimulus port
Out of Range
Error occurs. The command is ignored.
Query Response
<port>
Preset Value
1
Equivalent Softkeys
Measurement > Absolute > { A(1) | B(1) | R1(1) | A(2) | B(2) | R2(2) }