Copper Mountain Technologies S2 Series - Syst:comm:ecal:chec; Syst:corr

To Next Page

To Previous Page

S2VNA and S4VNA SCPI Programming Manual

384

SYST:COMM:ECAL:CHEC

SYSTem:COMMunicate:ECAL:CHECk

Description

Sets the CHECK state of AutoCal module (command only).

Equivalent Softkeys

None

SYST:CORR

SYSTem:CORRection[:STATe] {OFF|ON|0|1}

SYSTem:CORRection[:STATe]?

Description

Turns ON/OFF the system correction. The system correction is the

factory full 1-port calibration performed at the port connectors.

(command/query)

Parameter

{ON|1} : ON

{OFF|0} : OFF

Query Response

{0|1}

Preset Value

Equivalent Softkeys

System > Misc Setup > System Correction