Copper Mountain Technologies S2 Series

To Next Page

To Previous Page

S2VNA and S4VNA SCPI Programming Manual

261

SENS:CORR:COLL:TRLL

SENSe

<Ch>

:CORRection:COLLect[:ACQuire]:TRLLine

<port1>

<port2>

Description

Measures the calibration data of the TRL line standard between the

<port1> and the <port2>.

(no query)

Target

Channel <Ch>,

<Ch>={[1]|2|...16}

Parameter

<port1> the number of the port from 1 to 2 (or 4)

<port2> the number of the port from 1 to 2 (or 4)

Out of Range

If the same port numbers are specified, an error occurs.

Notes

The command starts the measurement immediately if the trigger source

for calibration set to the "Internal" by the command

SENS:CORR:TRIG:FREE, otherwise waits for the trigger signal. The

command blocks the execution of the subsequent commands until the

completion of the measurement.

Equivalent Softkeys

Calibration > Calibrate > n–Port TRL Cal > Line/Match

Copper Mountain Technologies S2 Series - Sens:corr:coll:trll