Copper Mountain Technologies S2 Series - Syst:pres; Syst:ready

S2VNA and S4VNA SCPI Programming Manual
393
SYST:PRES
SYSTem:PRESet
Description
Resets the Analyzer to the factory settings.
(no query)
Notes
The difference from the*RST: command is that the trigger is set to
the Continuous trigger mode.
Related Commands
*RST
Equivalent Softkeys
System > Preset > OK
SYST:READy?
SYSTem:READy[:STATe]?
Description
Reads out the ready state of the Analyzer. The state is True when
analyzer hardware is connected, powered and the boot process is
completed (about 10 sec).
(query only)
Query Response
{0|1}
Equivalent Softkeys
None