Copper Mountain Technologies S2 Series - Sens:corr:coll:thru

S2VNA and S4VNA SCPI Programming Manual
260
SENS:CORR:COLL:THRU
SENSe <Ch> :CORRection:COLLect[:ACQuire]:THRU <rcvport> , <srcport>
Description
Measures the calibration data of the thru standard between the
receiver port <rcvport> and the source port <srcport>.
(no query)
Target
Channel <Ch>,
<Ch>={[1]|2|...16}
Parameter
<rcvport> the number of the receiver port from 1 to 2 (or 4)
<srcport> the number of the source port from 1 to 2 (or 4)
Out of Range
If the same port numbers are specified, an error occurs.
Notes
The command starts the measurement immediately if the trigger source
for calibration set to the "Internal" by the command
SENS:CORR:TRIG:FREE, otherwise waits for the trigger signal. The
command blocks the execution of the subsequent commands until the
completion of the measurement.
Equivalent Softkeys
Calibration > Calibrate > Response (Thru) > Thru
Calibration > Calibrate > One Path 2–Port Cal > Thru
Calibration > Calibrate > Full 2–Port Cal > Port 1–2 Thru