Copper Mountain Technologies S2 Series - Sens:corr:ext:auto:port; Sens:corr:ext:auto:res

S2VNA and S4VNA SCPI Programming Manual
285
SENS:CORR:EXT:AUTO:PORT
SENSe <Ch> :CORRection:EXTension:AUTO:PORT <Pt> {OFF|ON|0|1}
SENSe <Ch> :CORRection:EXTension:AUTO:PORT <Pt> ?
Description
Turns ON/OFF the status of the auto port extension for the Port
number <Pt>.
(command/query)
Target
Port <Pt> of channel <Ch>,
<Ch>={[1]|2|...16}
<Pt>={[1]|2} for S2VNA or {[1]|2|3|4} for S4VNA
Parameter
{ON|1} : ON
{OFF|0} : OFF
Query Response
{0|1}
Preset Value
1
Equivalent Softkeys
Calibration > Port Extension > Auto Port Extension > Select Port(s)
SENS:CORR:EXT:AUTO:RES
SENSe <Ch> :CORRection:EXTension:AUTO:RESet
Description
Deletes the finished measurement data of OPEN and SHORT
standards of the auto port extension function. Allows to start
averaging again between the SHORT and OPEN standards.
(command/query)
Target
Channel <Ch>,
<Ch>={[1]|2|...16}
Equivalent Softkeys
Enter to the Auto Port Extension menu