Copper Mountain Technologies S2 Series User Manual

S2VNA and S4VNA SCPI Programming Manual
302
SENS:CORR:REC
SENSe <Ch> :CORRection:RECeiver <Pt> [:STATe] {OFF|ON|0|1}
SENSe <Ch> :CORRection:RECeiver <Pt> [:STATe]?
Description
Turns ON/OFF the receiver correction of the specified port.
(command/query)
Target
Port <Pt> of channel <Ch>,
<Ch>={[1]|2|...16}
<Pt>={[1]|2} for S2VNA or {[1]|2|3|4} for S4VNA
Parameter
{ON|1} : ON
{OFF|0} : OFF
Query Response
{0|1}
Preset Value
0
Equivalent Softkeys
Calibration > Receiver Calibration > Correction
SENS:CORR:REC:COLL:ACQ
SENSe <Ch> :CORRection:RECeiver <Pt> :COLLect:ACQuire <srcport>
Description
Executes receiver calibration of both the test receiver and the
reference receiver of the specified port <Pt>.The test receiver
calibration uses port number <srcport> as the source port. The
reference receiver calibration uses its own port <Pt> as the
source port.
(no query)
Target
Port <Pt> of channel <Ch>,
<Ch>={[1]|2|...16}
<Pt>={[1]|2} for S2VNA or {[1]|2|3|4} for S4VNA
Parameter
<srcport> the number of the source port from 1 to 2 (or 4)
Notes
The command starts the measurement of the calibration data
immediately regardless the trigger settings. The command blocks the
execution of the subsequent commands until the completion of the
measurement.
Equivalent Softkeys
Calibration > Receiver Calibration > Calibrate Both

Copper Mountain Technologies S2 Series Specifications

General

Brand	Copper Mountain Technologies
Model	S2 Series
Category	Measuring Instruments
Language	English